Roof Safety Mesh Requirements

If safety mesh is used ensure it.

Roof safety mesh requirements.

Therefore safety mesh always needs to be used with appropriate edge protection guardrails or fall arrest systems and devices. In order to better understand safety mesh please see the terms of roof safety mesh. For purlin spacing 1200 2200 mm fasteners to be fitted at maximum of 900 mm centres and minimum single lap. Safety mesh does not control the risk of falling from the perimeter or through penetration hazards.

Each safety net must be equipped with a border rope for webbing that maintains a minimum breaking strength of 5 000 pounds. Regarding safety net openings osha requires all openings to not exceed 36 square inches nor six inches on any side. 9 2 position of roof safety mesh roof safety mesh shall be positioned in accordance with the following. Safety mesh does not prevent falls from the edge of a roof or through unmeshed holes in a roof so.

Staging on the roof surface to spread the loads safety mesh secured under fragile roofing or skylights. A position of mesh where roof safety mesh is required it shall be fitted under the roof sheeting so that it is supported by metal and or timber purlins rafters or roof members that are part of the roof structure. Appropriate lifting technique for long roof conforms to as nzs 4389 2015 roof safety mesh is installed by a competent person in a safe manner and in accordance with the manufacturer s instructions. All mesh is to be lapped minimum of 150mm one square for purlins 2200 or greater to be lapped.